START UP PROCEDURES

All cables and adapters should be found in the video rack and FOH workbox drawers

• Projector is now permanently set up above stage
• Put projection screen together, and set it up on stage
• Set up video rack directly next to audio console at FOH
• Set up stage display TV behind FOH on top of road case
• Turn the rack and Resi decoder on by pressing three buttons
  1. CyberPower
  2. Furman
  3. Resi power
• Set up ProPresenter laptop on table next to rack
  • U: [email protected]
  • P: valprod1!
• Plug UltraStudio Monitor 3G into ProPresenter laptop, and connect to the back of the rack in port labeled “ProPresent”
• Plug SDI cable from the large loom into port labeled “SCREEN OUT” from the back of the rack
• Plug this SDI into the projector SDI input on stage behind the stage right curtains
• Plug projector power into outlet on side stage (3 prong outlet, not the 2 prong outlet)
• Plug HDMI adapter into ProPresenter laptop, and run long HDMI into the stage display TV
• Ensure stream (P2P) XLRs have been plugged in to the outputs on the back of the rack, and into inputs 1-6 on the audio console (see audio protocols for more info)
• Once projector is on, use remote to focus projector and align to screen
  • Focus → Hold down arrow keys to adjust focus (Best focus likely between 223 and 226)
  • Menu → Settings → Keystone → Quick Corner
• Import any new slides/songs from voxprod.rocks/content or campus specific slides from [email protected] email
  • Delete any outdated slides

Projector screen on stage

***Need to open both sides of feet, place against back wall and put 2 sand bags on each back foot: