START UP PROCEDURES

• Turn on lighting console computer
• Turn on all breakers at distro located stage right (leave breaker labeled OPTO’S on)
• Check haze fluid levels
  • Fluid levels in bottles should not go below 1/8 of a bottle
• Place all four Rogue lights along backline on stage, and chain them using DMX cable from side stage (next to distro), then DMX/PowerCon combo cables from lighting case
• Open lighting software (grandMA2) on lighting computer
• Turn on lighting console (rear rocker switch and power key)
• Load Vox Church show file
  • Press “Backup” in bottom right corner of console
  • Choose “Load Show”
  • Choose latest Vox Church show file and click “Load Show”
• Lamp on beams
  • Turn up their master fader on the console
  • Click “Lamp on”
  • Wait until you visually see all beams lamped on
  • Press the “Clear” button on the console three times to clear all selections
• RIGGING: Lower all black and legs
• FRONT LIGHTING: Place any specials that are being used

BREAKERS

GRANDMA3 CONSOLE POWER

*Power is located on back right corner of console

*Once rear rocker switch is flipped to “ON”, you can boot up console using round power key located on front face-panel